Description
Replacement intumescent hardwood door edging fits doors with a thickness between 40mm and 56mm. Supplied in 2100mm lengths. A complete door edging system with concealed intumescent and smoke seal. Supplied in a range of thicknesses to fit varying gap sizes.
Advantages
– Foor use with door gaps of 3mm, 5mm, and 7mm
– Can be used in conjunction with brush seals for larger gaps
– Edging is supplied in a sapele finish as standard, but other finishes are available
– Ideal for use in heavy-traffic areas where door edging is prone to damage, such as hospital corridors or hotel lobbies
Application Instructions
Remove the existing door edge with a sharp knife, chisel or saw, then rub down the edge with glass paper. If necessary (depending on the gap between door and frame), some planing may be required to allow for the replacement door edge. Replacement door edge fits flush one side (other side is wider to allow for planing down). Apply supplied glue to prepared door edge. Remove backing paper from self-adhesive strip on back of the replacement door edge. Press firmly into position. Hold the door edge firmly in place with masking tape while the glue sets (about 10-20 minutes). Finally, remove the masking tape and smooth down the projecting edge with a suitable plane and/or glass paper.
Order References / Sizes
ES46E 46mm x 7mm 2100mm smoke seal 5mm
For doors between 50mm and 56mm thick
ES56E 56mm x 7mm 2100mm smoke seal 5mm
When ordering state length of brush required, 5mm, 7mm or 10mm.